A. 2%
B. 2.5%
C. 3%
D. 4%
The camber for hill roads in case of bituminous surfacing is adopted as________________? Read More »
Highway Engineering, MCQs / Q&A A. sides towards the centre
B. centre towards the sides
C. lower edge towards the upper edge
D. upper edge towards the lower edge
A. 20 kmph
B. 30 kmph
C. 40 kmph
D. 50 kmph
The minimum design speed for hairpin bends in hill roads is taken as_______________? Read More »
Highway Engineering, MCQs / Q&A A. only on the hill side of road
B. only on the opposite side of hill
C. on both sides of road
D. none of the above
In hill roads the side drains arc provided________________? Read More »
Highway Engineering, MCQs / Q&A A. slog drain
B. catchwater drain
C. side drain
D. cross drain
A. mastic asphalt
B. sheet asphalt
C. bituminous carpet
D. bituminous concrete
A. mastic asphalt
B. sheet asphalt
C. bituminous carpet
D. bituminous concrete
A. Quantity of binder required for tack coat is less than that required for prime coat
B. Prime coat treatment is given for plugging the voids in water bound macadam during bituminous road construction
C. Seal coat is the final coat over certain previous bituminous pavements
D. A bitumen primer is a high viscosity cutback
Select the correct statement________________? Read More »
Highway Engineering, MCQs / Q&A A. 20 to 25 mm
B. 50 to 75 mm
C. 75 to 100 mm
D. 100 to 120 mm
The thickness of bituminous carpet varies from__________________? Read More »
Highway Engineering, MCQs / Q&A A. sheet asphalt
B. bituminous carpet
C. mastic asphalt
D. rolled asphalt
The suitable surfacing material for a bridge deck slab is________________? Read More »
Highway Engineering, MCQs / Q&A