A. Quartz
B. Silicates
C. Zinc particles
D. Aluminium
A. 300 mw/sm2
B. 350 mw/cm2
C. 400 mw/cm2
D. 450 mw/cm2
A. Tertiary amine
B. Benzoyl peroxide free radical
C. Hydroquinone
D. Methyl ether
A. Throughout the denture
B. Near the borders
C. In the thickest part
D. On the denture surface
A. Low compressive strength
B. High abrasive resistance
C. High water absorption
D. High polymerization shrinkage
A. Poor colour stability
B. Less polymerization shrinkage
C. Increase in vertical dimension
D. Decrease in vertical dimension
A. Zinc oxide
B. Methyl methacrylate
C. Phosphoric acid
D. Eugenol
A. Addition of grain refining agents
B. Addition of difunctional monomers
C. Increasing the amount of heat required for linear polymerization
D. Incorporation of terminating agents
A. Should be held at a millimeter distance from the restoration
B. Need no protection while in use
C. Will cure composite upto a depth of 5 millimeter thickness
D. Is fiber optic
A. Toluidine
B. Quaternary ammonium compound
C. Benzoyl peroxide
D. Tertiary amine