A. Amorphous
B. Cellular
C. Homogeneous
D. Granular
Wood is a/an ______________ material ? Read More »
Chemical Engineering Basics A. Compared to the mass flow rate of cooling water, the rate of condensation of steam is
invariably smaller
B. Maintaining vacuum on tube side is more difficult than that on the shell side
C. Water velocity can be increased conveniently to increase the overall heat transfer co-efficient
because of its lower specific volume compared to steam
D. Condenser can act as a storage unit for condensed steam
A. Sintering
B. Casting
C. Cold heading
D. Sning
Steel balls are manufactured by_____________________? Read More »
Chemical Engineering Basics A. Highly stressed parts
B. Gauges or precision parts
C. Cold rolled sheets
D. Non machinable materials
____________________ are normally subjected to sub-zero treatment? Read More »
Chemical Engineering Basics A. Flatness
B. Angle
C. Rotor balancing
D. Roughness
Auto collimator is used to check____________________? Read More »
Chemical Engineering Basics A. Turbulent
B. Viscous
C. Gravity
D. Pressure
__________________ fluid force is not considered in the Navier-Stokes equation? Read More »
Chemical Engineering Basics A. Profit maximisation
B. Customer satisfaction
C. Cost reduction
D. Process improvement
The most important consideration in value engineering is the_____________________? Read More »
Chemical Engineering Basics A. TNT
B. CMC
C. RDX
D. Lead azide
Which of the following is not an explosive ? Read More »
Chemical Engineering Basics A. 0°
B. 32°
C. 62°
D. 212°
‘Ice point’ is designated on Fahrenheit temperature scale by__________________? Read More »
Chemical Engineering Basics A. Iron and steel
B. Cement
C. Glass
D. Fertiliser
Maximum consumption of limestone is in the ____________________ industry? Read More »
Chemical Engineering Basics