Parson’s turbine is___________?
Parson’s turbine is___________?
A. pressure compounded steam turbine
B. simple single wheel, impulse steam turbine
C. simple single wheel reaction steam turbine
D. multi wheel reaction steam turbine
Parson’s turbine is___________?
A. pressure compounded steam turbine
B. simple single wheel, impulse steam turbine
C. simple single wheel reaction steam turbine
D. multi wheel reaction steam turbine
Steam turbines are governed by the following methods_____________?
A. Throttle governing
B. Nozzle control governing
C. By-pass governing
D. all of the above
The overall efficiency of thermal power plant is equal to____________?
A. Rankine cycle efficiency
B. Carnot cycle efficiency
C. Regenerative cycle efficiency
D. Boiler efficiency x turbine efficiency x generator efficiency
The maximum percentage gain in Regenerative feed heating cycle thermal efficiency____________?
A. increases with number of feed heaters increasing
B. decreases with number of feed heaters increasing
C. remains same unaffected by number of feed heaters
D. none of the above
Which of the following power plant usually offer highest maintenance cost___________?
A. Nuclear power plants
B. Hydro-electric power plants
C. Thermal power plants
D. Diesel engine power plant
In a regenerative surface condenser_____________?
A. there is one pump to remove air and condensate
B. there are two pumps to remove air and condensate
C. there are three pumps to remove air, vapour and condensate
D. there is no pump, the condensate gets removed by gravity
The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
A. 0.6
B. 0.578
C. 0.555
D. 0.5457