Load center in a power station is___________?
Load center in a power station is___________?
A. center of coal fields
B. center of maximum load of equipments
C. center of gravity of electrical system
Similar Posts
Load curve is useful in deciding the__________?
Load curve is useful in deciding the__________?
(a) A. operating schedule of generating units
B. sizes of generating units
C. total installed capacity of the plant
D. all of the aboveMethod which is commonly applied for unloading the coal for small power plant is___________?
Method which is commonly applied for unloading the coal for small power plant is___________?
A. lift trucks
B. coal accelerators
C. tower cranes
D. belt conveyorThe ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
A. 0.6
B. 0.578
C. 0.555
D. 0.5457If the diversity factor of a power station is high then its generation cost is___________?
If the diversity factor of a power station is high then its generation cost is___________?
A. high
B. low
C. remain same
D. depend on the plan typeWhich of the following load is responsible for lower power factor of supply system__________?
Which of the following load is responsible for lower power factor of supply system__________?
A. induction motors
B. resistive loads
C. synchronous Motors
D. all of the aboveDeaerative heating is done to_____________?
Deaerative heating is done to_____________?
Deaerative heating is done to
A. heat the water
B. heat the air in the water
C. remove dissolved gases in the water