If the centrifugal switch does not open at 70 to 80 percent of synchronous speed of motor, it would result in_________?
		A. damage to the starting winding
B. damage to the centrifugal switch
C. overloading of running winding
D. none of the above
		A. damage to the starting winding
B. damage to the centrifugal switch
C. overloading of running winding
D. none of the above
		A. is opposite to that of brush shift
B. is the same as that of brush shift
C. is independent of brush shift
		A. high inductance of field and armature circuits
B. induced current in rotor due to variations of flux
C. fine copper wire winding
D. none of the above
		A. inductor
B. capacitor
C. resistor
D. shading coils
		A. the motor will not start
B. the motor will run
C. the motor will run in reverse direction
D. the motor will run in the same direction at reduced r.p.m
		A. it is comparatively cheaper
B. it has almost non-destructible capacitor
C. it has low starting as well as running currents at relatively high power factor
D. it is quiet in operation
		A. run faster
B. spark at light loads
C. draw excessive current and overheat
D. run slower