[B].
[C].
[D].
Answer: Option B
Explanation:
No answer description available for this question.
A. int __ a3
B. int __ 3a
C. int __ A3
D. None of these
[B].
[C].
[D].
Answer: Option D
Explanation:
There are actually three different ways to configure the same default route, but only two are shown in the answer. First, you can set a default route with the 0.0.0.0 0.0.0.0 mask and then specify the next hop, as in option A. Or you can use 0.0.0.0 0.0.0.0 and use the exit interface instead of the next hop. Finally, you can use option D with the ip default-network command.
[B].
[C].
[D].
Answer: Option A
Explanation:
No answer description available for this question.
[B].
[C].
[D].
Answer: Option D
Explanation:
No answer description available for this question.
[B].
[C].
[D].
Answer: Option C
Explanation:
No answer description available for this question.
[B].
[C].
[D].
Answer: Option D
Explanation:
Hubs cannot run full-duplex Ethernet. Full duplex must be used on a point-to-point connection between two devices capable of running full duplex. Switches and hosts can run full duplex between each other, but a hub can never run full duplex.