Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by whitelisting our website.

Process Equipment and Plant Design

Weep holes provided in the plates of a distillation column ____________________?

Weep holes provided in the plates of a distillation column ____________________?

A. Facilitate draining out liquid from a tray when the unit is not in operation
B. Are normally located near the overflow weir so that any delivery of liquid during operation
follows approximately the same path as the overflow fluid
C. Must be large enough (usually 1/4″ to 5/8″ dia) to prevent plugging but should not deliver
excessive amount of fluid during operation
D. All A., B. and C.

Weep holes provided in the plates of a distillation column ____________________? Read More »

Process Equipment and Plant Design

Angled baffles are preferred in the agitation tank to control the swirling action; if the viscosity of the liquid to be mixed is about 200 poise. However, the baffle may be completely eliminated for mixing liquids having viscosity above ____________________ poise?

Angled baffles are preferred in the agitation tank to control the swirling action; if the viscosity of the liquid to be mixed is about 200 poise. However, the baffle may be completely eliminated for mixing liquids having viscosity above ____________________ poise?

A. 300
B. 600
C. 1000
D. 1500

Angled baffles are preferred in the agitation tank to control the swirling action; if the viscosity of the liquid to be mixed is about 200 poise. However, the baffle may be completely eliminated for mixing liquids having viscosity above ____________________ poise? Read More »

Process Equipment and Plant Design

Minimum tube pitch recommended for shell and tube heat exchangers is about _______________ times the outside diameter of the tube?

Minimum tube pitch recommended for shell and tube heat exchangers is about _______________ times the outside diameter of the tube?

A. 1.25
B. 1.75
C. 2.5
D. 3.5

Minimum tube pitch recommended for shell and tube heat exchangers is about _______________ times the outside diameter of the tube? Read More »

Process Equipment and Plant Design

In a shell and tube heat exchanger, triangular pitch arrangement as compared to square pitch arrangement ?

In a shell and tube heat exchanger, triangular pitch arrangement as compared to square pitch arrangement ?

A. Results in higher shell side pressure drop
B. Can accomodate less number of tubes for a given shell diameter
C. Facilitates easier shell side cleaning; hence is more suitable for handling high dirt factor shell
side fluid
D. Creates relatively lower turbulence on the shell side resulting in lower shell side heat transfer
co-efficient

In a shell and tube heat exchanger, triangular pitch arrangement as compared to square pitch arrangement ? Read More »

Process Equipment and Plant Design