The forces acting on the web splice of a plate girder are__________________? A. axial forces B. shear and axial forcesC. shear and bending forces D. axial and bending forces

Bearing stiffeners are provided at________________? i) the supports ii) the mid span iii) the point of application of concentrated loads The correct answer is? A. only (i) B. both (i) and (ii)C. both (i) and (iii) D. (i), (ii) and…

The maximum spacing of vertical stiffeners is_________________? A. 1.33 d B. 1.25 dC. 1.5 d D. 1.75 d where d is the distance between flange angles

The maximum permissible span of asbestos cement sheets is______________________? A. 650 mm B. 810 mm C. 1250 mmD. 1680 mm

The minimum thickness of plates in a steel stack should be___________________? A. 4 mm B. 5 mmC. 6 mm D. 8 mm

To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be_______________? A. 1B. 2 C. 3 D. 4

For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as__________________? A. zeroB. ±0.2p C. ± 0.5 p D. ±0.7p where p is basic wind pressure

The live load for a slog roof with slope 15°, where access is not provided to roof, is taken as_______________? A. 0.65 kN/m2 B. 0.75 kN/m2 C. 1.35 kN/m2 D. 1.50 kN/m2

The basic wind speed is specified at a height ‘h’ above mean ground level in an open terrain. The value of’h’ is__________________? A. 10 m B. 20 m C. 25 m D. 50 m

The external wind pressure acting on a roof depends on__________________? A. degree of permeability of roofB. slope of roof C. both (A) and (B) D. none of the above