Question: Bead wires are made of
[A].steel
copper
zinc
aluminium
[A].
[B].
[C].
[D].
Answer: Option A
Explanation:
No answer description available for this question.
Automobile Engineering
In radial tyres
Question: In radial tyres
[A].one ply layer runs diagonally one way and another layer runs diagonally the other way
all plies run parallel to one another and vertical to tyre bead
inner tubes are always used
none of these
[A].
[B].
[C].
[D].
Answer: Option B
Explanation:
No answer description available for this question.
In bias ply tyres
Question: In bias ply tyres
[A].all plies run parallel to one another
belts of steel mesh are used in the tyres
one ply layer runs diagonally one way and another layer runs diagonally the other way
all of the above
[A].
[B].
[C].
[D].
Answer: Option C
Explanation:
No answer description available for this question.
The basic purpose of tyres is to
Question: The basic purpose of tyres is to
[A].grip the road and provide good traction
substitute for springs
act as brake
none of these
[A].
[B].
[C].
[D].
Answer: Option A
Explanation:
No answer description available for this question.
The braking control type traction control system (TCS) generally operates in the speed range of
Question: The braking control type traction control system (TCS) generally operates in the speed range of
[A].less than 20 kmph
less than 40 kmph
less than 60 kmph
more than 60 kmph
[A].
[B].
[C].
[D].
Answer: Option B
Explanation:
No answer description available for this question.
A traction control system (TCS) in automobiles controls the
Question: A traction control system (TCS) in automobiles controls the
[A].vibrations on the steering wheel
engine power during acceleration
torque that is transmitted by the tyres to the road surface
stopping distance in case of emergency
[A].
[B].
[C].
[D].
Answer: Option C
Explanation:
No answer description available for this question.
Which of the following parameter can be adjusted by modifying the tie-rod attachment length ?
Question: Which of the following parameter can be adjusted by modifying the tie-rod attachment length ?
[A].Camber
Caster
Toe
Steering gear ratio
[A].
[B].
[C].
[D].
Answer: Option C
Explanation:
No answer description available for this question.
The ball joints are used on the tie-rod ends, because they
Question: The ball joints are used on the tie-rod ends, because they
[A].reduce the amount of noise generated
reduce the amount of sliding resistance
can deal with movement of the suspension both vertically and in other directions
improve the force transmission speed
[A].
[B].
[C].
[D].
Answer: Option C
Explanation:
No answer description available for this question.
In vehicles with tilt steering, the steering column is pivoted in
Question: In vehicles with tilt steering, the steering column is pivoted in
[A].upper bracket
lower bracket
tilt bracket
steering yoke joint
[A].
[B].
[C].
[D].
Answer: Option B
Explanation:
No answer description available for this question.
A worm gear is used as the pinion for the rack and pinion type of steering gearbox, because it
Question: A worm gear is used as the pinion for the rack and pinion type of steering gearbox, because it
[A].improves steering comfort when steering wheel is turned to effect small changes in the direction of forward motion
allows the steering wheel to be turned by a greater amount when steering
makes the steering more responsive
reduces the amount of kick-back for large steering angles
[A].
[B].
[C].
[D].
Answer: Option A
Explanation:
No answer description available for this question.