ECM is used to the sharp edges produced after rough cuts.
ECM is used to the sharp edges produced after rough cuts.
| Note: | The above multiple-choice question is for all general and Competitive Exams in India. |
Similar Posts
Gas flows through the nozzle from an area of pressure (called the chamber) to one of pressure
Question: Gas flows through the nozzle from an area of pressure (called the chamber) to one of pressure
A. high, low B. low, high C. same, same D. constant, infinite Answer» a. high, low Note: The above multiple-choice question is for all general and Competitive Exams in India. Which of the given reasons, is NOT a valid reason for packaging of food items?
Question: Which of the given reasons, is NOT a valid reason for packaging of food items?
A. security and portion control B. marketing and convenience C. protection and information transmission D. none of the mentioned Answer» d. none of the mentioned Note: The above multiple-choice question is for all general and Competitive Exams in India. The cost of additional control hardware remain a fraction of total machining cost.
Question: The cost of additional control hardware remain a fraction of total machining cost.
A. small B. large C. equal D. none of the mentioned Answer» a. small Note: The above multiple-choice question is for all general and Competitive Exams in India. The energy transfer between the hot fluid and cold fluids is brought about by their complete physical mixing in
Question: The energy transfer between the hot fluid and cold fluids is brought about by their complete physical mixing in
A. direct contact heat exchanger B. regenerators C. recuperators D. boilers Answer» a. direct contact heat exchanger Note: The above multiple-choice question is for all general and Competitive Exams in India. Hot tear
Question: Hot tear
A. Is a defect in castings B. Is a process involving heating C. Is a defect in wood D. Is a phenomenon occurring in materials ixposed to weather e.g. sun and rain Answer» a. Is a defect in castings Note: The above multiple-choice question is for all general and Competitive Exams in India. What is the advantage of having smaller ratio of water to steam space?
Question: What is the advantage of having smaller ratio of water to steam space?
A. steam can be generated at a faster even if the boiler is cold B. increases the rate of evaporation C. water is made cyclic, i.e., from boiler drum to water tube and back to drum D. helps in mobilizing the boiler Answer» a. steam can be generated at a faster even if the boiler is cold Note: The above multiple-choice question is for all general and Competitive Exams in India.