Skip to content
AnsweringExams.Com
  • Home
  • Contact Us / Report Error
  • Disclaimer

Month: February 2019

_____________ is the temperature at which a gas-vapor mixture becomes saturated, when cooled at constant total pressure out of contact with a liquid ?

August 22, 2021February 18, 2019 by admin
_____________ is the temperature at which a gas-vapor mixture becomes saturated, when cooled at constant total pressure out of contact with a liquid ?

A. Dew point
B. Bubble point
C. Dry bulb temperature
D. Wet bulb temperature

Categories Mass Transfer

For absorbers, high pressure drop results in___________________?

August 22, 2021February 18, 2019 by admin
For absorbers, high pressure drop results in___________________?

A. Increased efficiency
B. Decreased efficiency
C. High operating cost
D. Better gas liquid contact

Categories Mass Transfer

The binary diffusivity in gases at atmospheric conditions is about ___________________?

August 22, 2021February 18, 2019 by admin
The binary diffusivity in gases at atmospheric conditions is about ___________________?

A. 10-9 cm/sec
B. 10-1 cm2/sec
C. 10-3 sec/cm
D. 10-4 cm2/sec2

Categories Mass Transfer

Occurrence of ‘case hardening’ during drying of a high moisture solid cake _______________ the drying rate?

August 22, 2021February 18, 2019 by admin
Occurrence of ‘case hardening’ during drying of a high moisture solid cake _______________ the drying rate?

A. Increases
B. Decreases
C. Does not affect
D. Exponentially increases

Categories Mass Transfer

Refractory bricks are usually dried in a ________________ dryer?

August 22, 2021February 18, 2019 by admin
Refractory bricks are usually dried in a ________________ dryer?

A. Tray
B. Tunnel
C. Conveyor
D. Festoon

Categories Mass Transfer

The most common packing used in industrial operations is _______________ rings?

August 22, 2021February 18, 2019 by admin
The most common packing used in industrial operations is _______________ rings?

A. Raschig
B. Lessing
C. Cross-partition
D. Single spiral

Categories Mass Transfer

Capacity of a rotary dryer depends on its __________________?

August 22, 2021February 18, 2019 by admin
Capacity of a rotary dryer depends on its __________________?

A. rpm
B. Inclination with ground surface
C. Both A. and B.
D. Neither A. nor B.

Categories Mass Transfer

Berl saddle made of carbon cannot be used for ___________________?

August 22, 2021February 18, 2019 by admin
Berl saddle made of carbon cannot be used for ___________________?

A. Alkalis
B. SO2
C. H2SO4
D. Oxidising atmosphere

Categories Mass Transfer

For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of _______________ microns (1 mm = 1000 microns)?

August 22, 2021February 18, 2019 by admin
For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of _______________ microns (1 mm = 1000 microns)?

A. 1-5
B. 10-60
C. 200-300
D. > 500

Categories Mass Transfer

If G = insoluble gas in gas stream and L = non-volatile solvent in liquid stream, then the slope of the operating line for the absorber is___________________?

August 22, 2021February 18, 2019 by admin
If G = insoluble gas in gas stream and L = non-volatile solvent in liquid stream, then the slope of the operating line for the absorber is___________________?

A. L/G
B. G/L
C. Always < 1
D. None of these

Categories Mass Transfer
Older posts
Newer posts
← Previous Page1 … Page101 Page102 Page103 … Page448 Next →
© 2025 AnsweringExams.Com • Built with GeneratePress